Antimicrobial liquid glass sealant effective for up to 18 months – 20 ready-to-use sachet sets for 1m² area each.
Long-term surface protection suitable for smooth surfaces: Glass, stainless steel, aluminum and treated wood
Product features
- Eliminates bacteria (E.coli, S. aureus) and enveloped viruses (Corona, Ebola, Rota virus) up to 99.99%.
- Prevents the settlement of yeast and mold fungi
- Dermatologically tested “very good
- Surfaces become easier and faster to clean (“easy-to-clean”)
- For indoor and outdoor
- Abrasion resistant (increased scratch resistance)
- Simple and fast application
- Surface hardness on glass 9H (TÜV test according to MSZ EN ISO 15184:2013)
- Scratch hardness on glass 10N (TÜV test according to MSZ 9640/41:1983)
- Contact angle 95° on glass and 91° on stainless steel, after 10.000 cleaning cycles 92° + 85° (tested by TÜV with water)
- Layer thickness approx. 20 nm (nanometer)
- Roughness: 6 nm on the surface
- Sachets (individually packaged wet wipes)
- Sachet 1: Pre-cleaning cloth, soaked with IPA (isopropanol) 99%.
- Sachet 2: Sealing cloth, soaked with TiOSEPT® SG-55
- Viscose nonwoven, plastic-free, 60 g/m²
- Cloth size 100 x 140 mm
- One cloth is enough for about 1 m²
- BAUA Reg. No. N-104947
Application
TiOSEPT® SG-55 ready-to-use sachet set for smooth surfaces glass, stainless steel, steel, aluminum plastic and treated wood.
Pre-cleaning
It is recommended to wear disposable protective gloves. Application temperature 5 – 35°C.
- Clean the surface particularly carefully with commercially available cleaners. The better the cleaning, the longer the seal will last. Then dry the surface.
- Remove the alcohol pre-cleaning cloth from the sachet and thoroughly degrease the surface with it.
- Surface min. Allow to dry for 1 minute.
Sealing
It is recommended to wear disposable protective gloves. Application temperature 5 – 35°C.
- Remove the sealing cloth from the sachet and wipe the surface with it once vertically and once horizontally. The cloth is enough for about 1m². It is important that you work quickly, because the cloth is dry after about 90 seconds.
- Allow surface to dry for at least 2 minutes (below 15°C = 10 minutes), do not touch for 10 minutes. Full cure after 10 hours. Repeat application if necessary. If there is a slight gray creep, it can be carefully polished away with a microfiber cloth.
Plastic surfaces become antimicrobial and gain increased hydrophobicity, scratch resistance is not changed. Application on polycarbonate and Plexiglas® is not recommended.
storage
Store TiOSEPT® SG-55 at +5 to +25°C. Protect from frost and direct sunlight.
